Office of Scientific & Technical Information Technical Reports - 14,702 Matching Results

Search Results

Results: 1 - 24 next
open access

0-2 kv Flash Tube Supplies

Description: The power supplies designed and constructed to power high-intensity flash tubes are described. Three supplies, capable of charging 100 mfd to 2 kv with a repetltion rate of not less than 0.8 sec, are operated remotely from a control panel containing 3 powerstats. The power supplies are full wave center trapped rectifiers employing silicon rectifiers. (M.C.G.)
Date: March 15, 1962
Creator: Miller, D. M.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

04 nuclear safety: pressure piping crack monitoring detection of metal overstress by acoustic emission. Progress report, July-September 1966

Description: The three main areas of effort have been: (1) definition of the general acoustic response pattern related to the gross aspects of forming and extending a crack in various materials, (2) development of a monitor system prototype concept exclusive of transducers and (3) development of a suitable, high temperature transducer. Tests using double cantilever beam (DCB) specimens of various materials to establish conditions of crack formation and growth have indicated that material ductility is a majo… more
Date: October 28, 1966
Creator: Hutton, P H
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

6 kv CAPACITOR CHARGING SUPPLY

Description: The power supplies designed and constructed to power high intensity flash tubes used in bubble chamber experiments are briefly described and are accompanied by a schematic diagram of the layout. (D.C.W.)
Date: March 15, 1962
Creator: Miller, D. M.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

12-INCH SODIUM FLOW CONTROLLER. Technical Manual 20357

Description: A manual is presented for the Sodium Flow Controller used in controlling flow to regulate heat transfer in a liquid metal nuclear power plant. A description of the controller, general installation and operational pointers, installation instructions, instructions for dismantling of the Sodium Flow Controller, instructions for assembly of Sodium Flow Controller, list of special tools and fixtures, and repair parts list are given. (M.C.G.)
Date: October 31, 1962
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

12" SODIUM FLOW CONTROLLER. PERMANENT MAGNET COUPLING. MAGNETIC CALCULATION MANUFACTURE AND TEST RESULTS

Description: In order to retain the hermetic feature of the sodium flow controller, magnetic flux linkage of a permanent magnet coupling is used to transmit the torque produced by the operator through the pressure wall. Magnetic calculations, manufacture, and testing of this magnet coupling are described. (M.C.G.)
Date: August 18, 1961
Creator: Flator, H.E.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

13-Watt Curium-Fueled Thermoelectric Generator for Hard Lunar Impact Mission. Final Report-Subtask 5.8

Description: Results of a conceptual design study for a curium powered thermoelectric generator of minimum size and weight which is capable of sustaining hard impact is presented. The generator produces a minimum of 13 watts of d-c power at 3 volts, and weighs 6.2 pounds excluding shielding. (J.R.D.)
Date: August 1, 1960
Creator: Bloom, J. L.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

14-Inch Swing Check Valve Test

Description: The check valve for the Hallam Power Reactor uses a knife-edge bearing for the flapper in place of the usual journal-type bearing. Mechanical cycling in sodium at 600 deg F was used to check operation of this bearing. A total of 309 mechanical cycles was completed with no apparent malfunctioning of the valve. Measured leskage rates were 0.46 gpm at 0.93 psig, 0.73 gpm at 3.4 psig. and 0.32 gpm at 5.9 psig. (M.C.G.)
Date: February 10, 1960
Creator: Cygan, R.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

A 23-Group Neutron Thermalization Cross Section Library

Description: A set of 23-group neutron cross sections for use in the calculation of neutron thermalization and thermal neutron spectral effects in SNAP reactors is compiled. The sources and methods used to obtain the cross sections are described. (auth)
Date: July 15, 1963
Creator: Doctor, R. D. & Boling, M. A.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

40-MW(e) Prototype High-Temperature Gas-Cooled Reactor Research and Development Program. Quarterly Progress Report for the Period Ending June 30, 1962

Description: Research and development progress specifically directed toward the construction of a 40-Mw(e) prototype power plant employing a high-temperature, gas-cooled, graphitemoderated reactor known as the HTGR is reported. Irradiation of element III-B in the in-pile loop continued satisfactorily. The element has generated a total of l36.3 Mw-hr of fission heat. The gross activity in the purge stream increased slightly to about 350 mu C/cm/sup 3/. By taking larger gas samples than were previously taken,… more
Date: October 31, 1963
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

40-MW(E) PROTOTYPE HIGH-TEMPERATURE GAS-COOLED REACTOR RESEARCH AND DEVELOPMENT PROGRAM. Summary Report for the Period January 1, 1959-December 31, 1959 and Quarterly Progress Report for the Period October 1, 1959-December 31, 1959

Description: The HTGR prototype plant (Peach Bottom Power Reactor) is being designed to produce steam at l450 psi and 1000 deg F and to have a net capacity of 40 Mw(e). The fuel temperatures and gas pressures will be approximately the same as those required for larger plants. The reactor data and operating conditions for the graphite-clad core are given. The reactor and primary coolant systems are described. The prospects for development of the graphite-clad fuel element in time for use in the first loading… more
Date: September 1, 1960
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
Back to Top of Screen