National Advisory Committee for Aeronautics (NACA) - 124 Matching Results

Search Results

Results: 1 - 24 next
open access

The Aerodynamic Characteristics of Airfoils as Affected by Surface Roughness

Description: "The effect on airfoil characteristics of surface roughness of varying degrees and types at different locations on an airfoil was investigated at high values of the Reynolds number in a variable density wind tunnel. Tests were made on a number of National Advisory Committee for Aeronautics (NACA) 0012 airfoil models on which the nature of the surface was varied from a rough to a very smooth finish. The effect on the airfoil characteristics of varying the location of a rough area in the region o… more
Date: April 1933
Creator: Hooker, Ray W.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

The Aerodynamic Effect of a Retractable Landing Gear

Description: "Tests were conducted in the N.A.C.A. full scale wind tunnel at the request of the Army Air Corps to determine the effect of retractable landing gear openings in the bottom surface of a wing upon the characteristics of a Lockheed Altair airplane. The tests were extended to include the determination of the lift and drag characteristics throughout the angle-of-attack range with the landing gear both retracted and extended. Covering the wheel openings in the wing with sheet metal when the wheels w… more
Date: March 1933
Creator: DeFrance, Smith J.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

The Aerodynamic Forces and Moments Exerted on a Spinning Model of the NY-1 Airplane as Measured by the Spinning Balance

Description: From Summary: "A preliminary investigation of the effects of changes in the elevator and rudder settings and of small changes in attitude upon the aerodynamic forces and moments exerted upon a spinning airplane was undertaken with the spinning balance in the 5-foot vertical tunnel of the National Advisory Committee for Aeronautics. The tests were made on a 1/12-scale model of the "NY-1" airplane. Data by which to fix the attitude, the radius of spin, and the rotational and air velocities were t… more
Date: February 7, 1933
Creator: Bamber, M. J. & Zimmerman, C. H.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic tests of a low aspect ratio tapered wing with various flaps, for use on tailless airplanes

Description: From Introduction: "The tests described in this report are the first in an investigation by N.A.C.A. of the aerodynamic characteristics of possible tailless arrangements. The investigations will be extended to include whatever range is through most desirable and may include, among other things, variations in aspect ratio, taper, sweepback, washout, air-foil section, dihedral, and also control flaps or other control devices of different forms and proportions."
Date: June 1933
Creator: Weick, Fred E. & Sanders, Robert
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aircraft Power-Plant Instruments

Description: From Summary: "The report includes a description of the commonly used types and some others, the underlying principle utilized in the design, and some design data. The inherent errors of the instrument, the methods of making laboratory tests, descriptions of the test apparatus, and data in considerable detail in the performance of commonly used instruments are presented. Standard instruments and, in cases where it appears to be of interest, those used as secondary standards are described."
Date: May 31, 1933
Creator: Sontag, Harcourt & Brombacher, W. G.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aircraft speed instruments

Description: From Summary: "This report presents a concise survey of the measurement of air speed and ground speed on board aircraft. Special attention is paid to the Pitot-static air-speed meter which is the standard in the United States for airplanes. A bibliography on air-speed measurement concludes the report."
Date: 1933
Creator: Beij, K. Hilding
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

An airfoil spanning an open jet

Description: From Summary: "The first part of the report treats of the theory involved. The second part describes the experiments performed for the purpose of proving the theory."
Date: September 1933
Creator: Stüper, J.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Annual Report of the National Advisory Committee for Aeronautics (18th). Administrative Report Including Technical Report Nos. 401 to 440

Description: Report includes the National Advisory Committee for Aeronautics letter of submittal to the President, Congressional report, summaries of the committee's activities and research accomplished, bibliographies, and financial report.
Date: 1933
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Application of Practical Hydrodynamics to Airship Design

Description: The purpose of the first two parts of this report is to present in concise format all the formulas required for computation of the hydrodynamic forces, so that they can be easily computed for either straight or curvilinear flight. Improved approximations are also introduced having a high degree of accuracy throughout the entire range of practical proportions. The remaining two parts of the report are devoted respectively to stability and skin friction, as functions of the same hydrodynamic forc… more
Date: 1933
Creator: Upson, Ralph H. & Klikoff, W. A.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Attaining a Steady Air Stream in Wind Tunnels

Description: "Many experimental arrangements of varying kind involve the problems of assuring a large, steady air stream both as to volume and to time. For this reason a separate discussion of the methods by which this is achieved should prove of particular interest. Motors and blades receive special attention and a review of existent wind tunnels is also provided" (p. 1).
Date: October 1933
Creator: Prandtl, L.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Behavior of Vortex Systems

Description: Progressive application of the Kutta-Joukowsky theorem to the relationship between airfoil lift and circulation affords a number of formulas concerning the conduct of vortex systems. The application of this line of reasoning to several problems of airfoil theory yields an insight into many hitherto little observed relations. This report is confined to plane flow, hence all vortex filaments are straight and mutually parallel (perpendicular to the plane of flow).
Date: June 1933
Creator: Betz, A.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

The Boulton and Paul P.64 Mail-Carrier: A Two-Engine All-Metal Biplane

Description: Circular presenting a description of the Boulton and Paul P.64 high-performance mail-carrier. It is a two-engine tractor biplane that has been designed to give the specified normal speed with each engine throttled down to approximately half its output. Details of the landing gear, structural features, pilots' compartment, accommodation for mails, controls, power plant, and some flying qualities are provided.
Date: April 1933
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Charts for determining the pitching moment of tapered wings with sweepback and twist

Description: From Summary: "This report presents a convenient method for calculating the pitching-moment characteristics of tapered wings with sweepback and twist. The method is based on the fact that the pitching-moment characteristics of a wing may be specified by giving the value of the pitching moment at zero lift and the location of the axis about which the axis is constant. Data for calculating these characteristics are presented by curves which apply to wings having a linear distribution of twist alo… more
Date: December 1933
Creator: Anderson, Raymond F.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Comparison of Three Methods for Calculating the Compressive Strength of Flat and Slightly Curved Sheet and Stiffener Combinations

Description: "This report gives a comparison of the accuracy of the three methods for calculating the compressive strength of flat sheet and stiffener combinations such as occur in stressed-skin or monocoque structures for aircraft. Of the three methods based upon various assumptions with regard to the interaction of sheet and stiffener, the method based upon mutual action of the stiffener and an effective width as a column gave the best agreement with the results of the tests. An investigation of the effec… more
Date: March 1933
Creator: Lundquist, Eugene E.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

The Comper "Mouse" Commercial Airplane (British): A Three-Seat Cabin Low-Wing Monoplane

Description: Circular describing the Comper "Mouse" commercial airplane, which is a three-seat cabin low-wing monoplane. Details regarding the landing gear, wings, cabin, seating, fuselage, tail, power plant, controls, characteristics, performance, drawings, and photographs are provided.
Date: October 1933
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

A complete tank test of a model of a flying-boat hull - N.A.C.A. Model No. 11

Description: "This note discusses the limitations of the conventional tank test of a seaplane model. The advantages of a complete test, giving the characteristics of the model at all speeds, loads, and trim angles in the useful range are pointed out. The data on N.A.C.A. Model No.11, obtained from a complete test, are presented and discussed. The results are analyzed to determine the best trim angle for each speed and load. The data for the best angles are reduced to non-dimensional form for ease of compari… more
Date: July 1933
Creator: Shoemaker, James M. & Parkinson, John B.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

A Complete Tank Test of a Model of a Flying-Boat Hull - N.A.C.A. Model No.11

Description: "This note discusses the limitations of the conventional tank test of a seaplane model. The advantages of a complete test, giving the characteristics of the model at all speeds, loads, and trim angles in the useful range are pointed out. The data on N.A.C.A. Model No.11, obtained from a complete test, are presented and discussed. The results are analyzed to determine the best trim angle for each speed and load. The data for the best angles are reduced to non-dimensional form for ease of compari… more
Date: July 1933
Creator: Shoemaker, James M. & Parkinson, John B.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

A complete tank test of a model of a flying-boat Hull - N.A.C.A. model no.11-A

Description: Model No. 11-A was designed as an improvement over N.A.C.A. Model No. 11, a complete test of which is described in N.A.C.A. Technical Note No. 464. In contrast with the longitudinal upward curvature in the planing bottom forward of the main step on Model 11-A was made as flat as practicable. Otherwise, the two models have very nearly the same form. The results of towing tests made on Model 11-A in the N.A.C.A. tank over a wide range of speed, load on the water, and trim angle are presented, bot… more
Date: September 1933
Creator: Parkinson, John B.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

A Complete Tank Test of a Model of Flying-Boat Hull - N.A.C.A. Model 16

Description: "A model of a 2-step flying-boat hull, of the type generally used in England, was tested according to the complete method described in the N.A.C.A. Technical Note No. 464. The lines of this model were taken from offsets given by Mr. William Munro in Flight, May 29, 1931. The data cover the range of loads, speeds, and trim angles that may be of use in applying the hull form to the design of any seaplane. The results are reduced to nondimensional form to aid application to design problems and fac… more
Date: September 1933
Creator: Shoemaker, James M.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
Back to Top of Screen