150 Matching Results

Search Results

prev Results: 25 - 48 next
open access

The effect of spray strips on a model of the P3M-1 flying boat hull

Description: This note presents the results of a series of tests made in the N.A.C.A. tank on a one-sixth full-size model of the hull and side floats of the Navy P3M-1 flying boat for the purpose of finding a method of reducing the amount of spray thrown into the propellers of this craft when taking off and landing. The model was tested without spray strips and with five different spray-strip arrangements. The best arrangement was an improvement over the bare hull with no spray strips, but the improvement w… more
Date: December 1933
Creator: Dawson, John R.
Partner: UNT Libraries Government Documents Department
open access

Wind Tunnel Research Comparing Lateral Control Devices, Particularly at High Angles of Attack 8: Straight and Skewed Ailerons on Wings With Rounded Tips

Description: Tests showed the effect of the ailerons and the tip shapes on the general performance of the wing, as well as on the lateral control and stability characteristics. The hinge moments were not measured but the approximate values are given in the first report of the series.
Date: February 1933
Creator: Weick, Fred E. & Shortal, Joseph A.
Partner: UNT Libraries Government Documents Department
open access

Effect of aileron displacement on wing characteristics

Description: The effect of aileron displacement on wing characteristics has been investigated for the Clark Y and the U.S.A. 27 wing sections equipped with rectangular ailerons. The airfoils, rectangular in plan, and having a 10 inch chord and 60 inch span, were mounted on a model fuselage.
Date: February 1933
Creator: Heald, R. H.
Partner: UNT Libraries Government Documents Department
open access

The Effect of Split Trailing-Edge Wing Flaps on the Aerodynamic Characteristics of a Parasol Monoplane

Description: "This paper presents the results of tests conducted in the N.A.C.A. full-scale wind tunnel on a Fairchild F-22 airplane equipped with a special wing having split trailing-edge flaps. The flaps extended over the outer 90 percent of the wing span, and were of the fixed-hinge type having a width equal to 20 percent of the wing chord. The results show that with a flap setting of 59 degrees the maximum lift of the wing was increased 42 percent, and that the flaps increased the range of available gli… more
Date: November 1933
Creator: Wallace, Rudolf N.
Partner: UNT Libraries Government Documents Department
open access

The Aerodynamic Characteristics of Airfoils as Affected by Surface Roughness

Description: "The effect on airfoil characteristics of surface roughness of varying degrees and types at different locations on an airfoil was investigated at high values of the Reynolds number in a variable density wind tunnel. Tests were made on a number of National Advisory Committee for Aeronautics (NACA) 0012 airfoil models on which the nature of the surface was varied from a rough to a very smooth finish. The effect on the airfoil characteristics of varying the location of a rough area in the region o… more
Date: April 1933
Creator: Hooker, Ray W.
Partner: UNT Libraries Government Documents Department
open access

Wind tunnel research comparing lateral control devices, particularly at high angles of attack 11: various floating tip ailerons on both rectangular and tapered wings

Description: Discussed here are a series of systematic tests being conducted to compare different lateral control devices with particular reference to their effectiveness at high angles of attack. The present tests were made with six different forms of floating tip ailerons of symmetrical section. The tests showed the effect of the various ailerons on the general performance characteristics of the wing, and on the lateral controllability and stability characteristics. In addition, the hinge moments were mea… more
Date: May 1933
Creator: Weick, Fred E. & Harris, Thomas A.
Partner: UNT Libraries Government Documents Department
open access

The Effect on Engine Performance of Change in Jacket-Water Outlet Temperature

Description: Tests made on a Curtiss D-12 engine in the Altitude Laboratory at the Bureau of Standards show the following effects on engine performance of change in jacket-water outlet temperature: 1) Friction at all altitudes is a linear function of the jacket-water temperature, decreasing with increasing temperature. 2) The brake horsepower below an altitude of about 9,000 feet decreases, and at higher altitudes increases, with jacket-water temperature. 3) The brake specific fuel consumption tends to decr… more
Date: November 1933
Creator: Garlock, E. A. & Ellis, Greer
Partner: UNT Libraries Government Documents Department
open access

Full-Scale Wind-Tunnel Research on Tail Buffeting and Wing-Fuselage Interference of a Low-Wing Monoplane

Description: Some preliminary results of full scale wind tunnel testing to determine the best means of reducing the tail buffeting and wing-fuselage interference of a low-wing monoplane are given. Data indicating the effects of an engine cowling, fillets, auxiliary airfoils of short span, reflexes trailing edge, propeller slipstream, and various combinations of these features are included. The best all-round results were obtained by the use of fillets together with the National Advisory Committee for Aerona… more
Date: May 1933
Creator: Hood, Manley J. & White, James A.
Partner: UNT Libraries Government Documents Department
open access

The Effect of Rivet Heads on the Characteristics of a 6 by 36 Foot Clark Y Metal Airfoil

Description: "An investigation was conducted in the N.A.C.A. full-scale wind tunnel to determine the effects of exposed rivet heads on the aerodynamic characteristics of a metal-covered 6 by 36 foot Clark Y airfoil. Lead punching simulating 1/8 inch rivet heads were attached in full-span rows at a pitch of 1 inch at various chord positions. Tests were made at velocities varying from 40 to 120 miles per hour to investigate the scale effect" (p. 1).
Date: May 1933
Creator: Dearborn, Clinton H.
Partner: UNT Libraries Government Documents Department
open access

The effects of slots and flaps on lateral control of a low-wing monoplane as determined in flight

Description: This paper presents the results of flight tests made to determine the effect of slots and flaps on the lateral control of a low-wing monoplane. Maximum angular accelerations in roll and yaw produced by sudden application of the ailerons and maximum accelerations in yaw produced by sudden application of the rudder during gliding flight were recorded for the following wing arrangements: (a) no auxiliary device; (b) full-span slots; (c) plain flaps; (d) flaps and full-span slots; (e) wing-tip slot… more
Date: November 1933
Creator: Soulé, Hartley A. & Wetmore, J. W.
Partner: UNT Libraries Government Documents Department
open access

Strength Tests of Thin-Walled Duralumin Cylinders in Pure Bending

Description: "This report is the third of a series presenting the results of strengths tests on thin-walled cylinders and truncated cones of circular and elliptic section; it includes the results obtained from pure bending tests on 58 thin-walled duralumin cylinders of circular section with ends clamped to rigid bulkheads. The tests show that the stress on the extreme fiber at failure as calculated by the ordinary theory of bending is from 30 to 80 percent greater than the compressive stress at failure for … more
Date: December 1933
Creator: Lundquist, Eugene E.
Partner: UNT Libraries Government Documents Department
open access

A Complete Tank Test of a Model of Flying-Boat Hull - N.A.C.A. Model 16

Description: "A model of a 2-step flying-boat hull, of the type generally used in England, was tested according to the complete method described in the N.A.C.A. Technical Note No. 464. The lines of this model were taken from offsets given by Mr. William Munro in Flight, May 29, 1931. The data cover the range of loads, speeds, and trim angles that may be of use in applying the hull form to the design of any seaplane. The results are reduced to nondimensional form to aid application to design problems and fac… more
Date: September 1933
Creator: Shoemaker, James M.
Partner: UNT Libraries Government Documents Department
open access

The N.A.C.A. Combustion Chamber Gas-Sampling Valve and Some Preliminary Test Results

Description: "A gas sampling valve of the inertia-operated type was designed for procuring samples of the gases in the combustion chamber of internal combustion engines at identical points in successive cycles so that the analysis of the gas samples thus procured may aid in the study of the process of combustion. The operation of the valve is described. The valve was used to investigate the CO2 content of gases taken from the quiescent combustion chamber of a high speed compression-ignition engine when oper… more
Date: March 1933
Creator: Spanogle, J. A. & Buckley, E. C.
Partner: UNT Libraries Government Documents Department
open access

The Effect of Partial-Span Split Flaps on the Aerodynamic Characteristics of a Clark Y Wing

Description: "Aerodynamic force tests were made in the N.A.C.A. 7 by 10 foot wind tunnel on a model Clark Y wing with a 20 percent chord split flap deflected 60 degrees downward. The tests were made to determine the effect of partial-span split flaps, located at various positions along the wing span on the aerodynamic characteristics of the wing-and-flap combination. The different lengths and locations of the flaps were obtained by cutting off portions of a full-span flap, first from the tips and then from … more
Date: September 1933
Creator: Wenzinger, Carl J.
Partner: UNT Libraries Government Documents Department
open access

Experiments With a Counter-Propeller

Description: This note describes tests made at Stanford University on a four-blade fixed counter-propeller in combination with a two-blade rotating propeller. It is shown that the efficiency of the normal form, well-designed air propeller can be increased about two percent over the full working range by the addition of fixed counter-propeller blades.
Date: March 1933
Creator: Lesley, E. P.
Partner: UNT Libraries Government Documents Department
open access

Engine performance with a hydrogenated safety fuel

Description: From Summary: "This report presents the results of an investigation to determine the engine performance obtained with a hydrogenated safety fuel developed to eliminate fire hazard. The tests were made on a single-cylinder universal test engine at compression ratios of 5.0, 5.5, and 6.0. Most of the tests were made with a fuel-injection system, although one set of runs was made with a carburetor when using gasoline to establish comparative performance. The tests show that the b.m.e.p. obtained w… more
Date: July 1933
Creator: Schey, Oscar W. & Young, Alfred W.
Partner: UNT Libraries Government Documents Department
open access

Wind-Tunnel Research Comparing Lateral Control Devices, Particularly at High Angles of Attack 9: Tapered Wings With Ordinary Ailerons

Description: Tests were made with ordinary flap-type ailerons on two wings with different amounts of taper, one medium and the other extreme. On each wing both medium sized tapered ailerons and short wide tapered ailerons were tested.
Date: February 1933
Creator: Weick, Fred E. & Wenzinger, Carl J.
Partner: UNT Libraries Government Documents Department
open access

Mercerization of Cotton for Strength With Special Reference to Aircraft Cloth

Description: The object of the present investigation was to determine the conditions for mercerizing cotton yarn to obtain the maximum strength for a given weight. Apparatus for controlling the variables was built and yarns were mercerized with it under systematically varied conditions of tension, time, temperature, and concentration of caustic soda. The strongest conclusion to be drawn from this work is that the strongest mercerized yarn of a given count from a given quality of cotton is obtained under cer… more
Date: February 1933
Creator: Wilkie, J. B.
Partner: UNT Libraries Government Documents Department
open access

A study of factors affecting the steady spin of an airplane

Description: Data from wind-tunnel tests on a model of the NY-1 airplane were used in a study of the effect on the steady spin of a number of factors considered to be important. The factors were of two classes, mass distribution effects and aerodynamic effects. The study indicated that mass extended along the longitudinal axis has no detrimental effect or is even slightly beneficial, mass extended along the lateral axis is detrimental if the airplane spins with the inner wing tip far down, and mass extended… more
Date: August 1933
Creator: Scudder, Nathan F.
Partner: UNT Libraries Government Documents Department
open access

Wind tunnel research comparing lateral control devices, particularly at high angles of attack 10: various control devices on a wing with a fixed auxiliary airfoil

Description: Results are given of a series of systemic tests comparing lateral control devices with particular reference to their effectiveness at high angles of attack. These tests were made with two sizes of ordinary ailerons and different sizes of spoilers on a Clark Y wing model having a narrow auxiliary airfoil fixed ahead and above the leading edge, the chords of the main and auxiliary airfoils being parallel. In addition, the auxiliary airfoil itself was given angular deflection. The purpose was to p… more
Date: March 1933
Creator: Weick, Fred E. & Noyes, Richard W.
Partner: UNT Libraries Government Documents Department
open access

A Summary of Design Formulas for Beams Having Thin Webs in Diagonal Tension

Description: "This report presents an explanation of the fundamental principles and a summary of the essential formulas for the design of diagonal-tension field beams, i.e. beams with very thin webs, as developed by Professor Wagner of Germany" (p. 1).
Date: August 1933
Creator: Kuhn, Paul
Partner: UNT Libraries Government Documents Department
open access

A complete tank test of a model of a flying-boat Hull - N.A.C.A. model no.11-A

Description: Model No. 11-A was designed as an improvement over N.A.C.A. Model No. 11, a complete test of which is described in N.A.C.A. Technical Note No. 464. In contrast with the longitudinal upward curvature in the planing bottom forward of the main step on Model 11-A was made as flat as practicable. Otherwise, the two models have very nearly the same form. The results of towing tests made on Model 11-A in the N.A.C.A. tank over a wide range of speed, load on the water, and trim angle are presented, bot… more
Date: September 1933
Creator: Parkinson, John B.
Partner: UNT Libraries Government Documents Department
open access

Charts for determining the pitching moment of tapered wings with sweepback and twist

Description: From Summary: "This report presents a convenient method for calculating the pitching-moment characteristics of tapered wings with sweepback and twist. The method is based on the fact that the pitching-moment characteristics of a wing may be specified by giving the value of the pitching moment at zero lift and the location of the axis about which the axis is constant. Data for calculating these characteristics are presented by curves which apply to wings having a linear distribution of twist alo… more
Date: December 1933
Creator: Anderson, Raymond F.
Partner: UNT Libraries Government Documents Department
Back to Top of Screen