12 Matching Results

Search Results

Results: 1 - 12
open access

The S.A.B.C.A. "S.XI" Commercial Airplane (Belgian): A High-Wing Semicantilever Monoplane

Description: Circular describing the S.A.B.C.A. S.XI commercial airplane, which is a high-wing semicantilever monoplane. Details of the history of its creation, its design, components, engines, fuel tanks, characteristics, performances, drawings, and photographs are provided.
Date: April 1932
Creator: Frachet, André
Partner: UNT Libraries Government Documents Department
open access

The Mutual Action of Airplane Body and Power Plant

Description: The present report concerns the development of general propeller performance and r.p.m. curves which, combined with the general curve of the power required for level flight, presents a complete picture of the performance. The curve of power required for level flight in this paper is only an approximation for constant profile drag coefficient, meaning that it is not suitable to unconventional wing sections.
Date: April 1932
Creator: Schrenk, Martin
Partner: UNT Libraries Government Documents Department
open access

Application of the Theory of Free Jets

Description: Based upon Kirchoff's theory of free jets the flow through different screen arrangements of flat plates, as chiefly encountered with turbines in the cavitation zone is defined. It is shown by experiments that these theoretical results are very well representative in most cases of the conditions of discharge from water in air and consequently by cavitation. In addition, the experiments reveal a picture of the discrepancies between the actual flow and the theory of discharge of air in air (of wat… more
Date: April 1932
Creator: Betz, A. & Petersohn, E.
Partner: UNT Libraries Government Documents Department
open access

Development of Tailless and All-Wing Gliders and Airplanes

Description: Tailless airplanes are characterized by having all their control surfaces, especially the elevator, incorporated in the wings. This paper provides a discussion of the history of their development and current state of development.
Date: April 1932
Creator: Lademann, Robert W. E.
Partner: UNT Libraries Government Documents Department
open access

Considerations of air flow in combustion chambers of high-speed compression-ignition engines

Description: The air flow in combustion chambers is divided into three fundamental classes - induced, forced, and residual. A generalized resume is given of the present status of air flow investigations and of the work done at this and other laboratories to determine the direction and velocity of air movement in auxiliary and integral combustion chambers. The effects of air flow on engine performance are mentioned to show that although air flow improves the combustion efficiency, considerable induction, fri… more
Date: April 1932
Creator: Spanogle, J. A. & Moore, C. S.
Partner: UNT Libraries Government Documents Department
open access

Preliminary Investigation of Rolling Moments Obtained With Spoilers on Both Slotted and Plain Wings

Description: "A wind-tunnel study has been made to determine the possibility of developing spoilers suitable for providing the lateral control for airplanes in place of the usual ailerons. The first tests were made on a model wing with a fixed tip slot, but when it was found that the effectiveness of the spoilers did not depend to any great extent on the slot, tests were made on a plain wing also. In both cases certain spoiler positions were found which were free from the usual adverse rolling moments with … more
Date: April 1932
Creator: Weick, Fred E. & Wenzinger, Carl J.
Partner: UNT Libraries Government Documents Department
open access

Characteristics of Two Sharp-Nosed Airfoils Having Reduced Spinning Tendencies

Description: "According to Mr. L.D. Bell, of the Consolidated Aircraft Corporation, certain undesirable spinning characteristics of a commercial airplane were eliminated by the addition of a filler to the forward part of the wing to give it a sharp leading edge. To ascertain what aerodynamic effects result from such a change of section, two airfoils having sharp leading edges were tested in the variable-density wind tunnel. Both sections were derived by modifying the Gott. 398. The tests, which were made at… more
Date: April 1932
Creator: Jacobs, Eastman N.
Partner: UNT Libraries Government Documents Department
open access

The use of large valve overlap in scavenging a supercharged spark-ignition engine using fuel injection

Description: From Summary: "This investigation was conducted to determine the effect of more complete scavenging on the full throttle power and the fuel consumption of a four-stroke-cycle engine. The NACA single-cylinder universal test engine equipped with both a fuel-injection system and a carburetor was used. The engine was scavenged by using a large valve overlap and maintaining a pressure in the inlet manifold of 2 inches of mercury above atmospheric. The maximum valve overlap used was 112 degrees. Test… more
Date: April 1932
Creator: Schey, Oscar W. & Young, Alfred W.
Partner: UNT Libraries Government Documents Department
open access

The German Investigation of the Accident at Meopham (England)

Description: This report is a recounting of the German investigation of the crash of a commercial Junkers F 13 ge in England. The English report is examined and compared with the German interpretation of the accident.
Date: April 1932
Creator: Blenk, Hermann; Hertel, Heinrich & Thalau, Karl
Partner: UNT Libraries Government Documents Department
open access

Combustion Velocity of Benzine-Benzol-Air Mixtures in High-Speed Internal-Combustion Engines

Description: "The present paper describes a device whereby rapid flame movement within an internal-combustion engine cylinder may be recorded and determined. By the aid of a simple cylindrical contact and an oscillograph the rate of combustion within the cylinder of an airplane engine during its normal operation may be measured for gas intake velocities of from 30 to 35 m/s and for velocities within the cylinder of from 20 to 25 m/s. With it the influence of mixture ratios, of turbulence, of compression rat… more
Date: April 1932
Creator: Schnauffer, Kurt
Partner: UNT Libraries Government Documents Department
open access

Measurements of flow in the boundary layer of a 1/40-scale model of the U. S. Airship "Akron"

Description: This report presents the results of measurements of flow in the boundary layer of a 1/40-scale model of the U. S. Airship "Akron" (ZRS-4) made with the object of determining the boundary-layer thickness, the point of transition from laminar to the turbulent flow, and the velocity distribution in the boundary layer.
Date: April 27, 1932
Creator: Freeman, Hugh B.
Partner: UNT Libraries Government Documents Department
open access

Measurement of the Differential and Total Thrust and Torque of Six Full-Scale Adjustable-Pitch Propellers

Description: "Force measurements giving total thrust and torque, and propeller slip stream surveys giving differential thrust and torque were simultaneously made on each of six full-scale propellers in the 20-foot propeller-research tunnel of the National Advisory Committee for Aeronautics. They were adjustable-pitch metal propellers 9.5 feet in diameter; three had modified Clark Y blade sections and three had modified RAF-6 blade sections. This report gives the differential thrust and torque and the variat… more
Date: April 15, 1932
Creator: Stickle, George W.
Partner: UNT Libraries Government Documents Department
Back to Top of Screen