65 Matching Results

Search Results

Results: 1 - 24 next
open access

In-Core Instrumentation Development Program Quarterly Progress Report June - September 1963

Description: Introduction: The objective of Project Agreement 22 is to determine the feasibility of covering the complete reactor neutron flux start range from 10(3) - 5 x 10(13) nv by using in-core chambers. The counting mode of operating will be used at low neutron fluxes and the root mean square voltage fluctuation mode will be used at high neutron flux levels. Experiments have been run utilizing various ion chambers, gases, gas pressures, voltage, and cables to measure sensitivities and range operating … more
Date: October 1963
Creator: DuBridge, R. A.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Program for the Development of Plutonium Recycle for Use in Light Water Moderated Reactors Quarterly Progress Report: July 1 - September 30, 1963

Description: A research program is being conducted to obtain experimental data in the irradiation of plutonium-enriched fuel to confirm a theoretical model for predicting isotopic composition and reactivity changes in plutonium-enriched, light-water-moderated reactors. Quarterly progress: The densitometry procedure (for measurement of alpha autoradiographs of fuel pellets) has been modified to eliminate the need for a second emulsion. The existence of a problem of latent image fading and non-reciprocity of … more
Date: October 15, 1963
Creator: Robkin, M. A.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Accurate Nuclear Fuel Burnup Analyses; Eighth Quarterly Progress Report, (September - November 1963)

Description: The objective of the Accurate Nuclear Fuel Burnup Analyses program is to develop more accurate methods for burnup analysis for general use than the current method of analysis of Ca-137 or Sr-90. The program will require from three to five years of effort.
Date: December 1, 1963
Creator: Rider, B. F.; Ruiz, C. P.; Luke, P. S., Jr.; Peterson, J. P., Jr. & Smith, F. R.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Two-Phase Pressure Losses Quarterly Progress Report: Seventh Quarter, August 12, 1963 - November 11, 1963

Description: Technical report describing that the pressure drop along an annular channel with dimensions D(1) = 0.375 inch; D(2) = 0.875 inch, L = 70 inches. Flow was vertical and upward, and only the internal surface was heated. Subcooled conditions existed at the inlet, with two-phase conditions at the exit. Groups of three radial spacer pins on 18-inch centers along the channel, held the inner surface concentric with the outer surface. The single phase loss coefficient for each spacer group is K(8) = 0.2… more
Date: December 2, 1963
Creator: Janssen, E. (Engineer) & Kervinen, J. A.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Statistical Techniques Used in the Specific Zirconium Alloy Design Program

Description: Technical report describing the statistically designed empirical approach being used to choose a candidate Zr alloy optimum with respect to corrosion and hydriding rates in steam and having acceptable mechanical properties. The statistical techniques used and the reasons for their use are discussed in detail, with emphasis on the estimation of corrosion rates. Estimation of response surfaces is also considered.
Date: November 11, 1963
Creator: Jaech, John L.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Residual and Fission Gas Release from Uranium Dioxide

Description: Abstract: Residual and fission gas release from UO2 were studied in the laboratory and in in-reactor experiments. Arc-fused powder and sintered pellets were used to determine the rate of evolution and types of residual gases as a function of temperature. Fission gas release was related to the average UO2 temperature and fission gas release calculations were made using the latest thermal conductivity values, isotopic half lives, and branching ratios available in the literature. The results obtai… more
Date: July 15, 1963
Creator: Spalaris, C. N. & Megerth, F. H.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Grain Growth of UO2. Part I

Description: Abstract: (1) Grain growth in UO2 pellets was studies between 100 C and 2600 C. The pellets were encapsulated in small vacuum-tight tungsten containers in an argon atmosphere. (2) The grain size-time relationship could be expressed by an equation. A low exponent, m>_ 1/3, was found in those experiments and is related to the type of UO2 investigated. An activation energy of 65 kcal/mole was obtained for the grain growth process. The time exponent, m, increased with increasing temperature if the … more
Date: August 15, 1963
Creator: Hausner, H.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Physics Design of the Mixed Spectrum Critical Assembly

Description: Summary: The Mixed Spectrum Superheater (MSSR) is an integral superheater reactor in which boiling occurs in an annular Boiling Water Reactor section and steam in superheated in an unmoderated fast section in the center. A Mixed Spectrum Critical Assembly (MSCA) to be operated at the Vallecitos Atomic Laboratory has been designed to mock up a 75-150 MWe prototype MSSR. The principal experimental measurements aimed at proving the feasibility of the MSSR concept include power distribution, Dopple… more
Date: August 1963
Creator: Reynolds, A. B.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

The Measurement of Fission Gas Pressure in Operating Fuel Elements: Post-Irradiation Examination

Description: Summary: Two UO2-filled stainless steel clad fuel rods in which fission gas pressure was measured during irradiation have been subjected to post irradiation examination. Results of free gas analysis and metallographic examination are in general agreement with observed pressures reported previously. Calculated fuel surface temperatures based on extent of fuel recrystallization indicate that in a one-half inch diameter fuel rod with 0.014 inch diametral clearance operated at a maximum heat flux o… more
Date: September 20, 1963
Creator: Reynolds, M. B.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

High Power Density Development Project: Potter Meter Calibration and Instrumented Fuel Bundle Pressure Drop

Description: Summary: Technical report describing the testing of eight Potter Meters, for metering inlet flow and measuring exit steam qualities in the Consumers Big Rock Point Instrumented Fuel Assemblies, were individually calibrated for flow and pressure drop up to 500 gpm in the low temperature (130 F) fluid flow facility. The flow calibration comparison made with an ASME orifice installation, agreed to within + - 1 percent among seven of the meters, and meter Serial No. 8 was 2.8 percent lower than th… more
Date: July 26, 1963
Creator: Polomik, E. E. & Swan, C. L.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Nuclear Superheat Quarterly Project Report: Sixteenth Quarter, May-July 1963

Description: From introduction: "This is the sixteenth in a series of quarterly reports which cover the progress and results from the conceptual designs, economic evaluations and research and development work performed by the General Electric Company as part of Contract AT(01-3)-189, Project Agreement No. 13."
Date: August 15, 1963
Creator: Flock, W. L.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Multirod (Four Rod) Critical Heat Flux at 1000 PSIA

Description: Technical report describing the four-rod heat flux experiments that are a part of a continuing program of study of the critical heat flux, or burnout phenomenon in order that water cooled reactors can be designed with a maximum of safety and efficiency. During heat transfer with boiling, there is a particular heat flux, for a given set of flow conditions and geometry, above which the nucleate boiling process begins to break down. This breakdown of the nucleate boiling process is known as burno… more
Date: September 1963
Creator: Hench, John E.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Maritime Loop Irradiation Program for Savannah I Fuel Post-Irradiation Examination of SI5BM Fuel Assembly

Description: Abstract: A stainless steel clad 9-rod assembly fabricated by The Babcock & Wilcox Company was irradiated in a boiling water loop of the General Electric Test Reactor. A post-irradiation examination revealed no significant dimensional changes on the fuel rods. the results of mass spectrometric analysis made of the pelletized UO2 fuel indicated a maximum burnup of 11,500 MWD/tonne was attained by Rod B-4 during the exposure.An x-ray diffraction examination of an unirradiated fuel sample revealed… more
Date: November 7, 1963
Creator: Mathay, P. W.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Fuel Failure Examinations and Analyses in the High Power Density Program

Description: Summary: The High Power Density Project includes a comprehensive fuel development program which has the objective of developing and demonstrating the performance of a nuclear reactor core having a high power density, long fuel life, and low fabrication cost. The fuel program is made up of two principal tasks. Task 1A consists of irradiation tests in the VBWR of Type 304 stainless steel clad, UO2 pellet type fuel rods fabricated by current commercial processes. Task 1B consists of the investigat… more
Date: September 16, 1963
Creator: Arlt, W. H. & Vandenberg, S. R.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Two-Phase Pressure Losses Quarterly Progress Report: Sixth Quarter, May 12, 1963 - August 12, 1963

Description: Technical report describing that the pressure drops along 3/4-inch, 1-inch, and 1-1/4 inch straight pipes and across three contraction-expansion inserts in a 1-inch pipe have been measured under both single- and two-phase flow conditions. Pressure was varied from 600 to 1400 psia, flow from 0.25 x 10(6) to 1.66 x 10(6) lb/hr ft, and quality from zero to 90 percent. The single-phase pipe friction factor agrees with the Moody value for smooth pipe. The two-phase friction for horizontal flow shows… more
Date: September 1, 1963
Creator: Janssen, E. (Engineer) & Kervinen, J. A.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

A Program of Two-Phase Flow Investigation Quarterly Report: Second Quarterly Report, July-September, 1963

Description: Task A: Modification and Preparation of Experimental Facility. With the exception of the insulation of modified components, the experimental facility is complete. Insulation will be completed by the end of September. the system has been charged with Refrigerant-22 and preliminary loop performance tests have been completed without the test sections.. Task B: Design and Construction of Test Sections. The stainless steel test section has been prepared complete with end flanges and pressure tap loc… more
Date: September 23, 1963
Creator: Staub, F. W. & Zuber, N.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
Back to Top of Screen