Search Results

open access

VARI-II

Description: Writing the VARI-II Program was motivated by the need for a method of analyzing the results for the Absorber Burn-Up Experiment in progress at the Vallecitos Atomic Laboratory.
Date: March 10, 1961
Creator: Russell, J. L. (John L.), Jr.
Partner: UNT Libraries Government Documents Department
open access

A Program of Two-Phase Flow Investigation Quarterly Report: Fourth Quarterly Report, January-March, 1964

Description: Summary: The design, construction and assembly of all components were completed during the first contract year previous to December 1963. These efforts, defined by Tasks A-F, are document in (1), (2), and (3). Brief summaries of these completed efforts are given in the introduction to each of the tasks in the text of this report. The digest given below covers only the shakedown and analysis work carried out in the fourth quarter of the first contract year. Task G Shakedown Tests. The photo… more
Date: March 16, 1964
Creator: Staub, F. W. & Zuber, N.
Partner: UNT Libraries Government Documents Department
open access

Transition and Film Boiling Data at 600, 1000, and 1400 PSIA in Forced Convection Heat Transfer to Water

Description: Summary: Data were obtained in a two-road test section which consisted of two 7/16-inch diameter heater rods inside a roughly rectangular flow area. The heated length of the rods was 30 inches, with a 15-inch unheated calming length preceding it. Heater wall temperatures were recorded while the heater tubes were trans-versing the critical heat flux and transition boiling; these temperatures were used to calculate heat transfer coefficients. The following general results were obtaining: (a)… more
Date: March 1964
Creator: Hench, J. E.
Partner: UNT Libraries Government Documents Department
open access

Two-Phase Pressure Losses Quarterly Progress Report: Eighth Quarter, November 12, 1963 - February 11, 1964

Description: Technical report describing that voids were measured in a ½-inch by 1-3/4-inch channel with the S-1 insert (B(0)/B(1) = 0.4, L(0) = 0.1 inch), at 2 inches ahead of the insert (position A), ½-inch past the insert (position B), 5 inches past (position C), and 12 inches past (position D). The conditions were: P – 1000 psia, G = 1.00 x 10(6) lb/h-ft(2), and x = 18.8 percent. Average void and void distribution at position A are the same as for flow in a straight channel. Void distribution at posi… more
Date: March 1, 1964
Creator: Janssen, E. (Engineer) & Kervinen, J. A.
Partner: UNT Libraries Government Documents Department
open access

Erosion Experiments of Powder Compacted Uranium Dioxide Under Dynamic Steam Flow (Preliminary Report)

Description: Experiments were carried out to determine the erosion, oxidation and dimensional characteristics of purposely defected fuel elements containing unsintered UO2 powder prepared by the swaging technique. The experiments were conducted in an out-of-reactor loop under superheat conditions of pressure, temperature, flow velocity and steam chemical composition.
Date: March 21, 1961
Creator: Spalaris, C. N.; Comprelli, F. A. & Siegler, M.
Partner: UNT Libraries Government Documents Department
open access

Reactor Pressure Vessel Material Surveillance Program at the Garigliano Nuclear Power Plant

Description: Abstract: A materials exposure program has been established in the Garigliano Nuclear Power Plant to measure the effect of neutron irradiation and time at temperate on the mechanical properties of the reactor pressure vessel steel. Base metal specimens were made from portions of the pressure vessel steel, and weld heat-affected zone and weld metal samples were taken from a weldment made from the pressure vessel steel and simulating a pressure vessel circumferential weld since there are no longi… more
Date: March 1964
Creator: Brandt, F. A. & Kobsa, I. R.
Partner: UNT Libraries Government Documents Department
open access

AEC Fuel Cycle Program Design and Fabrication of Special Assembly 9-L : Irradiation Performance Test of UO2-Cermet Fuel

Description: Technical report describing a UO2-Mo cermet fuel assembly fabricated for long-term irradiation performance testing in the Vallecitos Boiling water Reactor. The design and fabrication histories of this assembly are described and pre-irradiation data on each individual rod are presented. Molybdenum was added to improve the bulk thermal conductivity of the fuel, so that fuel temperatures would remain comparatively low during high-power level operation of the fuel element. The molybdenum was inc… more
Date: March 1964
Creator: Ogawa, S. Y.
Partner: UNT Libraries Government Documents Department
open access

General Corrosion of Incoloy-800 in Simulated Superheat Reactor Environment

Description: The 300 series stainless steels had been selected originally as the reference fuel cladding material for utilization in several superheat reactor (SHR) systems being built as part of the United States Atomic Energy Commission (USAEC) program. The adequacy of the general corrosion resistance of Type-304 stainless steel for superheat fuel cladding was confirmed in the Phase I portion of the study reported previously. Fuel jacket failures that occurred in Type-304 stainless clad fuel elements exp… more
Date: March 1964
Creator: Pearl, W. L.; Brush, E. G.; Gaul, G. G. & Wozadlo, G. P.
Partner: UNT Libraries Government Documents Department
open access

Accurate Nuclear Fuel Burnup Analyses; Ninth Quarterly Progress Report, (December 1963 - February 1964)

Description: The objective of the Accurate Nuclear Fuel Burnup Analyses program is to develop more accurate methods for burnup analysis for general use than the current method of analysis of Ca-137 or Sr-90. The program will require from three to five years of effort.
Date: March 1, 1964
Creator: Rider, B. F.; Peterson, J. P., Jr.; Ruiz, C. P. & Smith, F. R.
Partner: UNT Libraries Government Documents Department
open access

Nuclear Superheat Quarterly Project Report: Eighth Quarter, April-June 1961

Description: From introduction: "This is the eighth of a series of quarterly reports which will cover the progress and results from the conceptual design, economic evaluations and research and development work performed by the General Electric Company as part of the Nuclear Superheat Project."
Date: March 1962
Creator: Pennington, R. T.
Partner: UNT Libraries Government Documents Department
open access

Nuclear Superheat Quarterly Project Report: Twelfth Quarter, April-June 1962

Description: From introduction: "This is the twelfth of a series of quarterly reports which will cover the progress and results from the conceptual design, economic evaluations and research and development work performed by the General Electric Company as part of the Nuclear Superheat Project."
Date: March 1963
Creator: Pennington, R. T.
Partner: UNT Libraries Government Documents Department
open access

VARI Solution of Simultaneous, First-Order, Ordinary, Differential Equations

Description: VARI solves on the IBM-650 a system of simultaneous, first-order, ordinary, differential equations. The program was written so that a large number of calculations could be done in a reasonable length of time. The program permits the consideration of the production of the isotope by absorption and/or decay of one or more of any of the other isotopes in the chain.
Date: March 15, 1960
Creator: Kerr, B. A.
Partner: UNT Libraries Government Documents Department
open access

General And Stress Corrosion Of High Nickel Alloys In Simulated Superheat Reactor Environment

Description: It is the purpose of this report to summarize the results of the evaluation program carried out to-date on the high nickel alloys Inconel, Incoloy and Hastelloy-X in the out-of-pile superheat facilities as part of Task E of the Atomic Energy Commission sponsored Superheat Program.
Date: March 1963
Creator: Pearl, W. L. & Gaul, G. G.
Partner: UNT Libraries Government Documents Department
open access

Two-Phase Pressure Losses: Fourth Quarterly Progress Report November 12, 1962 - February 12, 1963

Description: This is the fourth quarterly report on the work done under Contract AT(04-3)-189. The results reported here have to do primarily with single-phase loss and two-phase pressure drop in the 1/4" x 1-3/4" rectangular channel in the flow up and flow horizontal orientations, and two-phase pressure loss across two contraction-expansion inserts in the 1/2" x 1-3/4" channel.
Date: March 1, 1963
Creator: Janssen, E. (Engineer) & Kervinen, J. A.
Partner: UNT Libraries Government Documents Department
Back to Top of Screen