Search Results

open access

Absorption by Soil of Strontium From 216-S Crib Waste

Description: A preliminary soil column experiment with a waste sample from the 207-S-11 well, which monitors the 216-S cribs, indicated that cesium was absorbed almost completely by the soil but that strontium breakthrough to ground water in the near future seemed likely. Accordingly, it was suggested that the 216-S wastes be discharged to a new disposal site, and that samples of the wastes which are currently being discharged to the 216-S cribs be obtained for soil absorption tests. The primary purpose of … more
Date: February 15, 1956
Creator: Rhodes, D. W.
open access

The Alpha Half-Life of the Isotope Pu-241

Description: A plutonium solution of known Pu-241 content was purified by solvent extraction techniques to remove uranium and americium impurities. Portions of this purified solution were then analyzed for U-237 as a function of time. Since the growth of U-237 occurs directly by the alpha decay of Pu-241, these measurements provided sufficient data for calculation of the Pu-241 alpha half-life, which was found to be 2.91 ± 0.50 x 10⁵ years.
Date: February 15, 1955
Creator: Gift, M. W.
open access

Analytical procedures for the plutonium Metal Fabrication Process

Description: A report describing a the results of a fluorimetric and volumetric method for the determination of fluoride. This method was developed for the determination of ionizable fluorine in gases in the range of 1-500ppm. This method was chosen because the determination depends on the generation of a color rather than the bleaching effect or on a change of color.
Date: January 15, 1951
Creator: Kendall, L. F.
open access

Comments on Engineering Review of PRTR by Atomic Power Equipment Department

Description: On a project of the magnitude and complexity of the Plutonium Recycle Test Reactor is was considered prudent engineering practice to obtain an independant design review by a competent off-site group that had not participated in any way in the development of the design. Accordingly, the Atomic Power Equipment Department of the General Electric Company was requested to make such an engineering review, and an Assistance to Hanford contract authorizing this work was approved by the Atomic Energy Co… more
Date: October 15, 1959
Creator: Reactor and Fuels Researcg and Development Operation Hanford Laboratories Operation
open access

Design Criteria for PRTR High Pressure Loop Project CAH-841

Description: The PRTR pressure loop is an experimental facility to be installed in the Plutonium Recycle Test Reactor, Building 309, for use in testing the feasibility of reactor cooling systems utilizing high pressure water or steam as the coolant. It will furnish operating experience with such systems and serve to test fuel elements and components designed to operate in such environments.
Date: October 15, 1959
Creator: Fox, J. C.; Jakub, M. T. & Kelly, W. S.
open access

Determination of Americium

Description: The following report describes a successful procedure used for the determination of americium in the presence of plutonium. Provided are articles listed that describe the research done in developing the method.
Date: October 15, 1952
Creator: Schmidt, H. R.
open access

Division of Reactor Development Programs Monthly Report- August 1959

Description: Sinterability studies on mixtures of UO2 and PuO2 powders have been continued. All of the censities from previous sintering experiments have been recalculated utilizing a somewhat different water immersion technique. Since densities of pellete obtained by physical dimensions are inaccurate due to chipping, and water immersion does not account for the open porosity, the pellets were coated with clear krylon before being immersed in water. This effectively sealed the open pores. Plots of density … more
Date: September 15, 1959
Creator: McEwen, L.H.
open access

Division of Reactor Development Programs Monthly Report- December 1958

Description: Two Zircaloy-clad capsules (GKH-14-19,20) containing two compacts each of high density PuO2-UO2 mixed crystal oxides were shipped to the MTR in December 2, 1958. The compacts contain 0.026 a/o PuO2, have densities of 91 percent of the theoretical value, and will generate the same specific power as an Al-1.8w/o Pu alloy rod of the same diameter would produce. Two capsules (GKH-14-21,22) have been prepared and contain three compacts each of low density, about 65 percent of the theoretical value, … more
Date: January 15, 1959
Creator: McEwen, L.H.
open access

Division of Reactor Development Programs Monthly Report - February 1959

Description: Plutonium Oxide Fuels. Mixtures of PWR grade UO2 containing 10, 20, 30, 40, 50, and 60 w/o PuO2 were sintered in hydrogen for 44 hours at 1600 C to get additional data on solubility in this system. Densities of all the pieces were low, approximately 80 percent of theoretical; however, solid solution formation was complete in every case. The low density material should not affect lattice parameter values, but it did slightly reduce the intensity of the reflections.
Date: March 15, 1959
Creator: McEwen, L.H.
open access

Division of Reactor Development Programs Monthly Report- March 1959

Description: Basic Studies. It has been reported previously that mixed crystals of PuO2 and UO2 have a higher sintering rate than UO2 alone. However, results to the contrary were obtained on addition to 1/4, 1/2, 1, 2, 5, and 10 w/o PuO2 to PWR grade UO2. Pellets of the above concentrations were heated for one hour in hydrogen at 100 C intervals from 1000 to 1600C.
Date: April 15, 1959
Creator: Hanford Laboratories Operation Fuels Preparation Department, Irradiation Processing Department
open access

Division of Reactor Development Programs Monthly Reports-June 1959

Description: Basic Studies. Sinterability experiments in the system UO2-PuO2 have continued, and data are available at one hour hold times across the UO2-PuO2 composition limits. Sintered densities appear to be markedly dependent on pressed densities with densification occurring very rapidly at higher pressing pressures. The following table illustrates the effect of one hour at temperature on final density for pure plutonium dioxide pressed to both 40 and 60 percent of theoretical density.
Date: July 15, 1959
Creator: Lewis, M.
open access

Effects of Furnance Pressures on Quality of Remelted Uranium : Final Report, Production Test 314-59-M

Description: The following report follows a test for remelting and casting uranium scrap specified that a pressure of 25 microns or less must be attained within the furnace before a charge is melted. The report was made to evaluate the effect of furnace pressures upon the quality if recast uranium metal.
Date: February 15, 1951
Creator: Kattner, W. T.
open access

Effects on the Inhour Equation for Reactors Fueled with Mixtures of Fissionable Material

Description: The determination of various parameters such as thermal utilization, resonance escape probability, control rod calibrations and etc. is often accomplished by the measurement of the pile period due to some given perturbation. With the present thoughts being directed towards plutonium fueled reactors, it was felt worthwhile to discuss a few of the basic differences in pile neutron behavior due to the smaller fraction of delayed neutrons per fission of Pu239 and the larger fraction of delayed neut… more
Date: June 15, 1956
Creator: Astley, E. R.
Back to Top of Screen